E.T. Systems E PAD, Руководство пользователя

Страница: 7 / 9

7
Ver.201105.007
Using the keypad
Normal operation:-
To activate the lock relay, simply type in a valid code for that relay or press and release the free exit push button if one
has been installed:
-The lock relay will activate as it was setup by the installer.
-The green LED indicator will activate as per the relay.
To activate the auxiliary relay, simply type in the valid code for that relay:
-The auxiliary relay will activate as it was setup by the installer.
-The yellow auxiliary LED will activate as per the relay.
Alarm monitoring conditions:-
If the alarm monitoring has been set up by the installer, the following will occur.
Alarm output, built in buzzer and flashing green LED will activate immediately an alarm condition occurs.
The follow are alarm conditions available:

Door opened without a valid code entry first. (Door forced alarm)

Door not closed by the time the lock relay resets. (Door kept open alarm)

Keypad housing opened. (Tamper alarm)
After the alarm time (set by the installer) has expired, the alarm output and the built in buzzer resets. However, the
flashing green LED continues until the first valid user code is entered into the keypad. This way the user is made aware
that an alarm condition occurred even after the built in buzzer and alarm output have reset.
Bypass function:-
NEVER USE WITH SOLENOID TYPE STRIKERS or LOCKS!
In cases such as an office park or school gate, that need to temporarily be kept open to allow for peak traffic periods,
the bypass function can be used. This function requires a dedicated code which is set up by the master code holder.
When the bypass code is entered, the lock relay will latch on until either the bypass code is entered again or the free
exit push button is pressed.
While the bypass function is active, no other lock relay user code will release the relay.
This function is also useful where a magnetic lock is installed.