Getting Started - 9
The AudioDock
The AudioDock connects to the E-MU 1010 PCI card via the EDI cable. The front of the AudioDock provides 2 balanced
mic/line preamp inputs, 1 set of MIDI I/O ports, a stereo optical S/PDIF output and a stereo headphone output.
Front Panel Connections
Preamp Section
The front panel mono Mic/Line inputs A & B can be used as balanced microphone inputs, hi-Z guitar pickup
inputs, or balanced line level inputs. The Neutrik combination jack accepts microphones using a standard XLR
connector or line level/hi-Z inputs using a 1/4 inch TRS phone plug.
Warning:
Some microphones cannot tolerate phantom power and may be damaged. Check the microphone’s
specifications and requirements before using phantom power.
MIDI 1 In/Out
MIDI input and output ports allow you to interface any type of MIDI equipment such as keyboards, effect units,
drum or guitar controllers. The MIDI drivers were installed when you installed your Patchmix DSP software and
the MIDI ports will appear in your system control panel under “Sounds and Audio Devices”.
A Line
Mic
Clip
-12 dB
+20 dB
+25 dB
+55 dB
-10 dB
Line -
Mic -
B Line
Mic
Clip
-12 dB
+20 dB
+25 dB
+55 dB
-10 dB
48V
MIDI 1
In
Out
Out
S/PDIF
MIDI
CLOCK
SMPTE
1
2
48
192
IN
OUT
96
44.1
LCK
EXT
2
Insert 1/4"
Plug for Line Level
Phantom
Power On/Off
Signal/Clip
Indicators
Input Gain
Controls
MIDI #1
I/O Jacks
Headphone
Output
Headphone
Volume
S/PDIF
Optical Out
LED
Indicators
Insert XLR Plug
for Mic Level
+20dB to +55dB Gain
-10dB to +25dB Gain
