3
Note:
1. This product should be programmed by RC-07.
2. Please contact the distributor near you to obtain correct/updating of product information.
3. Please refer to each manual of HC-12/RP-12/RP-10 for the details of scene (macro) setting.
4. Appliances Activatation Setup
A. Procedure:
a.
Press & hold
a key, punch
Setup Button
with a
Setup Stick
(
punch – feel a click & let go
), after
LED flash
3 times
&
off
, use
setup stick
to punch the
setup button
again, & observe the LED
blinking
.
b.
The Sequence
of Blinking
1st 2nd 3rd
4th
5th
6th
7th
8th
9th 10th
Constant ON
for 1 Sec.
Macro
No. 1 2 3 4 5 6 7 8 9 10 Clear
C.
As above table,
press any key as LED blinking sequence no. indicates the macro you want to
assign. & it will confirm the assignment with
blinking LED
with
time
s as the
macro no.
you’ve
choose.
ex.:
If the linked macro
no. 7,
is what you need;
when the LED
blinks the 7
th
,
touch
any key
on
LS-330T panel,
& the LED will blink
7 times
to confirm the
macro
you’ve selected.
At last, the 3 LED will blink 2 times together to leave the setting mode.
- If you touch any key as the LED ON for 1 Sec., it means “Clear”, no linked macro code assigned in
this setting.
- The setting cycle is once at a time, if you do nothing under setting mode. The system will be
recovery after LED blinks 10 times & constant ON for 1 Sec.
B. Control:
a.)
Touch the key to send a
Linked Macro Activating Code
to
a controller
nearby
,
after it finished all
its preset
2-Way / Macro Control
action.
b.
)
Touch any key to
break off
the action as LC-X0T is transmitting actions.
Annex A
：
Panel Install / uninstall
[
Uninstall
]
Put the sucker on the marked spot, press to squeeze out air
& make sure the sucker is fixed, then pull out of the panel.
[
Install
]
There are 2 latches on the top of the panel, & a crystal in the
buttom. there is 2 slot for those 2 latches & a magnet for
crystal. PLS make sure the direction correctly. Slide latches
into slots first then press the crystal side into the magnet side
till the panel sink completely.
Pull
！
