Carefully unpack your heater and remove the wheel assemblies from the
packaging.
1. MAKE SURE THE HEATER IS UNPLUGGED AND TURNED OFF.
2. CAREFULLY PLACE THE HEATER UPSIDE DOWN.
3. Insert the “Wheel Assembly Clamps” into the base of the heater, between
the first & second panel at one end and the eighth & ninth panel at the
other end of the heater.
4. Insert the open end of the “Wheel Assembly Clamps” into the holes of one
of the support bars of the “Caster Wheels Assembly”
5. Insert the Wing nuts and screw them in tightly.
6. Repeat steps 3 & 4 with the second “Wheel Assembly Clamp” and support
bar of the “Caster Wheels Assembly”
7. Turn your heater to the upright position.
8. Your heater is now ready to use.
WARNING:
Only operate the heater in the upright position with the wheels on
the bottom and controls on top. Operating the heater in any other position and
without the wheel assemblies attached could result in personal injury, property
damage and/or damage to your heater.
OPERATING INSTRUCTIONS
