“
ENERGY SAVING
,
ECOFRIENDLY PODUCT
”.
IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed in
order to reduce the risk of fire, electric shock, and injury. Carefully read all of the
instructions below before using this heater.
1.
This heater is hot when in use. To avoid burns, do not let bare skin touch
the heater’s hot surfaces. Use the provided handle when moving this
heater.
2.
Keep items such as pillows, bedding, linens, curtains, clothes, paper and
furniture at least 2.5 feet (0.5m) from the front of the heater. Keep these
items away from the sides and rear of the heater.
3.
Use extreme caution when the heater is used by or near children, disabled
or whenever the heater is left operating unattended.
4.
The appliance should always be in the upright position when in use.
5.
Do not cover the heater, this may cause overheating.
6.
Do not place or use the heater in wet or damp locations such as
bathrooms or laundry areas. Never place the heater where it might fall
into or near water and do not use the heater to dry wet clothes.
7.
Do not use this heater in or near areas where gasoline, paint or other
such liquids are used or stored.
8.
Do not use the power supply cord to move the appliance. The power
supply cord should not touch the heating panels while in use. Do not run
the power supply cord under carpeting or cover with throws or rugs. Keep
away from traffic areas where it will not be tripped over.
9.
Disconnect the power supply cord when not in use. Ensure the controls
are turned off and then remove the plug from the outlet.
10.
Do not operate the heater if it has a damaged cord or plug, after the
heater malfunctions, has been dropped or damaged in any manner.
Return the heater to an authorized dealer for any repairs & adjustments.
11.
Only use this heater as described in the owner’s manual. Any other
method used may cause fire, electric shock or injury.
12.
Avoid the use of extension cords. If extension cords must be used,
minimize the risk of overheating by using a UL listed, minimum # 14AWG
and rated no less than 850 watts.
UNPACKING AND SET-UP INSTRUCTIONS
