6
EN
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code
of a single specifi c transmitter. You need to ‘bind’ your chosen Spektrum
™
DSM
®
technology equipped
aircraft transmitter to the receiver for proper operation.
For a list of compatible DSM2/DSMX transmitters, please visit www.bindnfl y.com.
CAUTION:
When using a Futaba
®
transmitter with a Spektrum DSM module, you must reverse the
throttle channel and rebind. Refer to your Spektrum module manual for binding and failsafe instructions.
Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.
Transmitter and Receiver Binding
Binding Procedure Reference Table
1. Refer to your transmitter’s unique instructions for binding to a receiver.
6
5
2. Make sure the fl ight battery is disconnected from the aircraft.
3. Ensure the transmitter is powered OFF.
4. Connect the fl ight battery to the aircraft. The receiver LED will begin to
fl ash (typically after 5 seconds).
5. Make sure the transmitter controls are at neutral and the throttle is in
the low position.
6. Put your transmitter into bind mode.
(If you are using the transmitter that is supplied with the RTF version,
push the left control stick vertically into the case (until it clicks) while
powering ON the transmitter).
7. After 5 to 10 seconds, the receiver status LED will become solid,
indicating that the receiver is bound to the transmitter. If the LED does
not turn solid, refer to the Troubleshooting Guide at the end of the
manual.
For subsequent fl ights, power ON the transmitter for 5 seconds before connecting the fl ight battery.
Transmitter Batteries Installation
3
4
1
2
6
5
Your E-fl ite
®
4-channel DSM2
®
/
DSMX
®
RTF transmitter comes
pre-bound to the aircraft.
Remove the cover, install four
of the included batteries (noting
proper polarity) and reinstall the
cover.
