E-FLITE UMX AS3Xtra, Инструкция по эксплуатации

Страница: 6 / 18

6
EN
Alternate Flight Mode Programming
Default
Flight
Mode
Alternate
Flight
Mode
Ch 5
Switch
Position
Mode Programming
Stick Positions
(Mode 2 shown)
General
Flight
Standard
AS3X ®
0
Standard
AS3X ®
Knife
Edge
Assist
1
Hover
Assist
Torque
Roll
Assist
2
Reset all to Default Settings
Out of the box, the AS3Xtra comes standard with 3
fl ight modes, shown in bold in the chart to the right.
A transmitter with a 2-position channel 5 switch will
only allow the use of position 0 or position 2 fl ight
modes.
If possible (refer to your transmitter manual) assign
channel 5 in your transmitter to a 3 position switch
to operate all 3 fl ight modes. You can modify the
fl ight modes available using the directions below.
NOTICE: Fast forward flight in the Hover and
Torque Roll Assist modes may cause oscillation
and damage to the aircraft.
IMPORTANT: Your transmitter must be bound to the
receiver before changing fl ight mode programming.
1. Ensure all servo reversing is set to normal in
the transmitter.
2. Hold the transmitter sticks as shown, then
connect the flight battery. The assigned flight
mode switch does not need to be in a
particular position.
3. The receiver LED will flash 3 times to confirm
that the flight mode has been changed.
4. After a switch position change, fully lower the
throttle, then disconnect the flight battery. The
receiver stores the new flight mode for future
flights.
5. Repeat this process to change other flight
modes, or reset all settings to default using the
chart provided.
NOTICE: Always launch the aircraft in General Flight
or Standard AS3X
®
mode or damage to the aircraft
may result.
I MPORTANT: When the throttle is fully lowered for
1–2 seconds, the aircraft will reset to Standard
AS3X mode until the throttle is raised again. This is
normal. Standard AS3X mode allows you to launch
the model again without a control input being held.
Flight Mode Benefi ts
Def
ault
General
Flight
Heading hold on ailerons,
standard AS3X on elevator and
rudder.
Standard
AS3X Standard AS3X on ailerons,
elevator and rudder.
Hover
Assistance Aggressive heading hold on
ailerons, elevator and rudder.
Alternate
Knife Edge
Assist Heading hold on ailerons,
elevator and rudder.
Torque Roll
Assist
Standard AS3X on ailerons,
aggressive heading hold on
elevator and rudder.