26
E-flite LR-1A Pogo 15e ARF Assembly Manual
5. Repeat Steps 1 through 4 to secure the rudder
servo in the fuselage. The rudder servo is on the
right side of the fuselage.
6. Use hook and loop tape to install the receiver in
the fuselage. Plug a 3-inch (76mm) servo extension
in the throttle channel of the receiver. Plug the
leads from the rudder and elevator servos into the
receiver at this time. Plug the lead from the speed
control into the 3-inch (76mm) servo extension.
Route the servo leads so they are neatly tucked
under the servo tray and won’t interfere with the
operation of the aileron servo.
7. Secure the remote receiver in the fuselage using
hook and loop tape.
Rudder and Elevator
Linkage Connections
Required Parts
Fuselage assembly Nylon control horn (2)
Transmitter
Control horn backplate (2)
Battery
Nylon pushrod keeper (2)
Silicone keeper (2)
2mm x 12mm sheet metal screw (4)
Required Tools and Adhesives
Pin vise
Drill bit: 5/64-inch (2mm)
Felt-tipped pen
Long nose pliers
Side cutter
Square or straight edge
Ruler
Phillips screwdriver: #1
1. Connect a nylon control horn to the clevis of the
rudder pushrod wire. The clevis attaches to the hole
one-in from the end of the horn as shown.
