E-FLITE Blade mCX, Инструкция по эксплуатации

Страница: 8 / 20

E-flite LP5DSM Spektrum DX5e
E-flite HP6DSM Spektrum DX6i
ParkZone Vapor Transmitter Spektrum DX7
JR X9303 2.4 Spektrum Modules
JR 12X 2.4
Note: The Spektrum DX6 (SPM2460) is equipped with DSM (not DSM2)
technology and is not compatible with the receiver/5-in-1 of the Blade mCX
BNF.
The following steps outline the binding process:
• Confirm the process of entering the bind mode for your chosen
transmitter by reviewing the instruction manual included with the
transmitter.
• Make sure the flight battery is disconnected from the 5-in-1 unit and the
transmitter is turned off.
• Plug the flight battery into the 5-in-1 unit. After 5 seconds the LED on the
5-in1 unit will begin flashing.
• After verifying the LED is flashing on the receiver/5-in-1 follow the steps
that allow your chosen transmitter to enter bind mode.
• If you entered bind mode correctly, you will see a solid LED approximately
5-10 seconds later on the receiver/5-in-1. You should now be bound to the
transmitter, and have full control and function.
If you encounter any problems, repeat the binding process again or call the
Horizon Support Team at 1-877-504-0233.
12 13
Mode 2
Throttle Trim Buttons
Aileron Trim Buttons
Elevator Trim Buttons Rudder Trim Buttons
Mode 1
Elevator Trim Buttons
Aileron Trim Buttons
Throttle Trim Buttons Rudder Trim Buttons
Rudder/Throttle
Functions
Rudder/Elevator
Functions
Aileron/Elevator
Functions
Aileron/Throttle
Functions
Transmitter Control Identification
Note: Each time before you fly you should ALWAYS turn the
transmitter on before connecting the flight battery to the 5-in-1
unit. After each flight, be sure that you always disconnect the flight
battery from the 5-in-1 unit before powering the transmitter off.
Note: The E-flite MLP4DSM transmitter is shown for reference only.