7
E-flite 4-Site Assembly Manual
Wing Installation
Required Parts
Fuselage assembly Top wing
Bottom wing
Outer strut (2)
Required Tools and Adhesives
Square
Foam-safe CA
1. Locate the bottom wing.
2. Test fit the fuselage into the bottom wing as
shown. Make sure the tabs from the fuselage are
flat when inserted into the bottom wing. If not, you
may induce an airfoil resulting in unwanted flight
characteristics.
If the tail of your airplane is hanging off of the table
when you are mounting the bottom and top wing it will
allow the assembly to lay perfectly flat against the joint.
3. After confirming the fit between the fuselage
and bottom wing, use foam-safe CA to glue the
bottom wing to the fuselage. Use a square between
the fuselage and bottom wing to keep them in
alignment while the CA fully cures.
4. Locate the two outer struts. There is not a left
or right strut, but you will want to match the trim
scheme from right to left for aesthetics.
Содержание 4-Site
Страница 29: ...29 E flite 4 Site Assembly Manual ...
Страница 30: ...30 E flite 4 Site Assembly Manual ...
Страница 31: ...31 E flite 4 Site Assembly Manual ...