E-FLITE 4-Site, Инструкция по сборке, Страница: 18 / 32

18 E-flite 4-Site Assembly Manual

9. Locate three of the pushrod supports and slide
the supports onto the pushrod as shown in the
second photo.

10. Insert the pushrod guides into the slots in the
fuselage. In each position, there is a pair of holes.
The rudder pushrod supports go in the rear hole of
each pair. Do not glue the supports yet.

11. Align the pushrod with the rudder control horn.

12. The pushrod is supplied slightly long to
accommodate for servo selection and control horn
position. Use side cutters to trim the pushrod so it
almost touches the rudder control horn.

13. Slide a piece of heat shrink on the pushrod
and control horn.
Only use a soldering iron to shrink the
tubing for the control rods. A heat gun or
lighter will damage the control surfaces.
Use care not to touch the soldering iron
to any of the control surfaces.
You will notice that there is extra heat shrink
supplied with the kit. This is in case you
lose one or need to redo a linkage.