ACC-CX3RDK-CU5640
Getting Started Manual
28-Apr-2014
www.e-consystems.com
| Subject to change without notice
Page 4 of 9
2 Introduction
ACC-CX3RDK-CU5640 Board is a camera daughter board has been designed and developed by
e-con Systems India Pvt Ltd. The ACC-CX3RDK-CU5640 Board uses e-CAM51_CU5640_MOD
custom Lens camera module based on OV5640 CMOS sensor from Omnivision. This camera
daughter board can be directly interfaced to the Denebola - CX3 RDK board from e-con Systems.
This document describes how to interface the ACC-CX3RDK-CU5640 Board on Denebola - CX3
RDK board and how to use the same.
3 Scope
The scope of this document is limited to the description of the camera daughter board and how to
interface this daughter board on Denebola - CX3 RDK board. This also lists down any
precautions to be taken, if any.
4 Disclaimer
The specifications of the camera daughter board and instructions on how to use this daughter
board with Denebola - CX3 RDK board are provided as reference only and e-con Systems
reserves the right to edit/modify this document without any prior intimation of whatsoever.
5 Description
The ACC-CX3RDK-CU5640 Board designed to interface e-CAM51_CU5640_MOD with the
Denebola - CX3 RDK board. The ACC-CX3RDK-CU5640 Board accommodates the OV5640 5M
pixel Custom Lens camera module. OV5640 is a low voltage high performance color CMOS
sensor from Omnivision. This board contains an onboard oscillator, the necessary voltage source,
power and reset sequence to support the functionality of this camera module on Denebola - CX3
RDK board.
Figure 1: ACC-CX3RDK-CU5640 Board
5.1 Interface Connector Pin Description
The ACC-CX3RDK-CU5640 Board connects to the Denebola - CX3 RDK board through a 52-pin
camera connector (CN2). The following table lists down the pin numbers and signal names of this
camera header.
