STEP 4: (i) (x2) Fasten the back center support to the arms thru the pocket holes in the back center support into the pre drilled
holes in the arm by using 2 – 1 ½” stainless steel pan head screws on each side (making sure that the pocket hole and the
mortise for the arm support are facing up). (j) (x2) To install the arm assembly place the arm support into the mortis in the
arm. (k) (x2) Fasten the arm support to the arm by firmly holding the arm in place and using 2 – 1 ½” stainless steel pan head
screws thru the pocket holes in the top of the arm support (use 2” #2 bit). (l) Line up the bottom of the back center support
with the bottom of the notch in the two outside back slats, then fasten the back center support to the rocker back assembly
by using 6 – 1 ½” stainless steel pan head screws thru the pre drilled holes in the back center support DO NOT OVER TIGHTEN.
(i)
(j)
(k)
(l)
ecwoutdoorfurniture.com
