E.C.A. GeliosPlus 11, Инструкция по установке и эксплуатации пользователя

Страница: 9 / 36

ASSEMBLY
Determination of the Location where the Device will be Assembled
- It should be conformed to the rules determined by TSE and authorized gas institutions for the
locations where the device may be assembled.
- If the device had been assembled inside a cabinet, the distances required for maintenance and
repair should be at least as in Figure 3.
- 2 vents should be made at the bottom and on top of the cabinet, and the vents prevent the
heating up of the device by enabling the ventilation of the cabinet. For the vents of the cabinet, that
are directly in contact with outdoor air, areas of 220 cm' should be left.
As the exterior surface temperature of the device doesn't exceed 85
°
C at maximum heating power,
special protective measure against flammable construction materials and elements is not required.
The following limitations have been imposed by TSE and authorized gas institutions for the
locations where the hermetic device will be assembled. Assembly of devices should be performed
at
• Stairwells of the buildings,
• Corridors of the buildings which are open for general use,
• On the flue walls,
/ J
• At skylights of buildings.
(
1------
J
Figure 3
Do not assemble your combi boiler at locations where it will be exposed to
direct sunlight.Sunbeams may cause color change on the exterior surface of
your device.
DANGEROUS:
The location where your hermetic device will be assembled and
location of hermetic flue outlet should conform to instructions specified y TSE
and authorized gas institutions.
7