Operation
Timer On/Off On-Off Operation
TURBO/QUIET Operation
1.After unit starts, select your desired operation mode.
2.Press
/ button to change TIMER mode.
Timer On Timer off
Turbo/Quiet
Auto
Press
Timer On
button "
ON
0.5 " will appear ,after 10 seconds
2
Cool
Heat
Dry
the time display will be blank.
Press
Timer off
button "
OFF
0.5 " will appear ,after 10 seconds
When you need fast cool or fast dehumidification,you
can choose the Turob function; when you sleep, read,
you can choose Quiet function
the time display will be blank.
Then select your desired TIMER mode (TIMER ON or
TIMER OFF ). "
"will flash.
"or "
Press the
bu on, you can switch the “Turbo”
Turbo/Quiet
3.Press
/
button to set time.
Timer On Timer off
and “Quiet”
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
will swith as below
（
TURBO
）
（
QUIET
）
cancel
4.Confirm timer setting
After adjust the time,press
button and confirm the
Confirm/Cancel
When running in Turbo
，
the fan speed is the highest,
when running in Quiet, the fan speed is super slow
time ON or OFF button will not flash any more.
5.Cancel timer setting
Press the button the time display eliminated.
Confirm/Cancel
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either Start-Stop or Stop-Start can be
achieved.
Loading of the battery
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
is in line with th
e" + "/"-";
HEALTH Operation
(This function is unavailable on some models.)
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
Press HEALTH button , the remote controller will show
and then achieve to the health function.
Press again this HEALTH button , the
health function will be
cancelled.
The anion generato
r
in the airconditioner can generate
a lot of anion effectively balance the quantity of position
and anion in the air and also to kill bacteria and speed
up the dust sediment in the room and finally clean the
air in the room.
When electronic-started type fluorescent lamp or change- over
type fluorescent lamp or wireless telephone is installed in the
room, the receiver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
remove the batteries and reload several minutes later.
4
