E.C.A. ARCEUS 6 kW MT, Руководство по установке

Страница: 2 / 38

1 - ASSEMBLY
1 .1- Selection of Device’s Assembly Location
The location where the device can be assembled and spaces to be left around it for safety,
service, maintenance, and use purposes must be as shown in Figure 10.
Figure 10: Indicates the minimum spaces to be left from the top and sides of the device
(Dimensions are given in mm).
For correct service and maintenance of the combi boiler, the installation should be carried out in
accordance with the following minimum spaces. The position of the combi boiler must be checked in
accordance with the technical rules.
Upper side service space
Min. 500 mm.
Bottom side service
space
Min. 250 mm.
Left and right side
servicee space
Min. 150 mm.
Figure 10- Required spaces for the assembly of the device
- The device can not be used at altitudes higher than 2000 m above sea level.
- There is no need to remove side panels for the inside combi boiler service operations. Min. 50
mm spaces are given by considering a possible side panel sheet replacement.
- Do not assemble your combi boiler in places where it will be exposed to direct sunlight. Sun
exposure can cause discoloration on the outer surface of your device over time.
- The ambient temperature of the device’s assembly location must be between 5 - 35 °C.
- The device must not be assembled outdoors.
- The device must not be assembled on devices with a direct steam outlet.
- The device must not be assembled in areas where it can be at risk of direct water exposure.
- The device must not be assembled on damp places such as bathtubs, shower cabinets and
must be assembled at least 50 cm away from these areas.
- Since the outer surface temperature of the device does not exceed 85°C at maximum heating
power, no special protective measures are required for combustible building materials and
components.
1 .2- Wall Mounting of the Device
After determining the place where the combi boiler is mounted:
EN
2