Rev. 4.0
37
[email protected] • www.e-breathe.de
e-breathe Smartblower
a) Assembly Belt & BeltClip
Connect the belt with the belt clip. The SVE is worn on the belt and the belt clip is used to attach the motor unit and
the particle filter.
Remove the belt buckle. Insert the belt through the slots of the belt clip and then reattach the buckle of the belt.
Fig. 6
Disassembly Belt & BeltClip
Remove the buckle from the belt and pull the belt out of the slots of the belt clip.
b) Assembly GurtClip, BeltClip, Motor Unit & Particle Filter
The motor unit is placed on the recess of the belt clip and held in place. The particle filter is hand-tightened from
below through the recess of the belt clip in the internal thread of the motor unit in a clockwise direction.
Fig. 7
Disassembly BeltClip, Motor Unit & Particle Filter
To separate the motor unit from the belt clip, unscrew the particle filter counterclockwise from the motor unit.
4.2.3.1 Assembly One Filter Mode
g
Hood System
4.2.3.2 Assembly Two Filter Mode
g
Hood System
Disassembly Motor Unit & Full Mask
Unscrew the yellow union nut of the motor unit counterclockwise from the full face mask.
b) Assembly Motor Unit & Particle Filter
Screw the particle filter into the motor unit by hand in a clockwise direction.
Fig. 5
Disassembly Motor Unit & Particle Filter
Unscrew the particle filter counterclockwise from the motor unit.
4.2.3 Assembly One Filter Mode & Two Filter Mode
g
Hood System
Information: The following steps 4.2.3.1 Assembly one-filter mode and 4.2.3.2 Assembly two-filter mode explain
the assembly of the respective unit individually. Jump directly to the point of your unit.
i
a) Assembly of the Smartbelt & Y-Connector Carrying System
Attach the Y-connector to the Smartbelt carrying system. At the Smartbelt the Y-Connector, two particle filters, the
motor unit and the SVE are carried.
Position the Y-connector centrally over the rim of the Smartbelt. The Y-connector‘s 3 fixing points should be located
at the 3 attachment points of the rim.
Figure 8-9-10
Press the Y-connector evenly down into the rim. Make sure that all 3 fixing points of the Y-connector are pressed
down. Then screw the Y-connector clockwise until it stops. The Y-connector will then be firmly connected to the sys-
tem. Fig. 11-12
Disassembly of the Smartbelt & Y-Connector Carrying System
To disassemble, press the Y-connector evenly downwards and unscrew it counterclockwise from the rim.