E-Blox
®
is not responsible for parts damaged due to
incorrect wiring.
If you suspect you have damaged parts, you can
follow this procedure to systematically determine
which ones need replacing:
1. Lamp (76), LED (69), Colorful LED (72):
Place part
directly across the battery holder as shown; it should light.
Make sure the LEDs are installed in the correct direction.
If they do not light, then replace your batteries and repeat.
If they still fail to light, then the battery holder is damaged.
4. Switch (62), Press switch (61), Reed Switch (83),
4-Wire Block (4):
Use this circuit to test each switch and
the wire blocks. The lamp (76) and bi-directional LED (71)
should light. If they don’t light, then the switch or wire block
is bad. Follow the steps below:
With the switch (62) in the circuit - Up position, the lamp
(76) and bi-directional (71) should be off, Down position, the
lamp and bi-directional LED should be lit.
Replace the Switch (62) with the Press Switch (61) – the
lamp and bi-directional LED should light when the switch is
pressed.
Replace the Press Switch (61) with the Reed Switch (83) -
When you place the magnet on the switch the lamp and bi-
directional LED should light.
Replace the Reed Switch
(83) with each of the three
Wire blocks (4) - Test the
wire blocks one at a time.
The lamp and bi-directional
LED should light when you
connect the wire blocks.
2. Bi-directional LED (71):
Place the LED across the
battery holder; it should light in both directions.
3. Motor (95):
Place the motor across
the battery holder (95 at top) as
shown; it should spin clockwise.
Red
Blue
Advanced Troubleshooting
(adult supervision recommended)
-13-
E-Blox
®
880 Asbury Dr., Buffalo Grove, IL 60089 U.S.A.
Phone / Fax: (855) MY EBLOX (693-2569)
e-mail: [email protected]
l
Website: www.myeblox.com
You may order additional / replacement parts at:
www.pickabrick.com
EBX59_Manual_051717_Layout 2 5/17/2017 11:09 AM Page 14
