Dynon SkyView HDX System, Руководство по настройке

Страница: 7 / 27

SkyView HDX System Configuration Manual; Beechcraft Bonanza P35 - V35B, Revision A Page | 1
1 Introduction
This document provides guidance to correctly configure the SkyView HDX system when installed
in a Beechcraft P35 through V35B Bonanza.
This document assumes that SkyView and its components have been wired in accordance with
document 103488-000 Wiring Diagram, Typical HDX Dual Display.
Dynon provides an associated configuration file which should be loaded before beginning the
configuration process:
103738-000
– Rev A - SkyView HDX System Configuration – Bonanza P35-V35B.dfg
This file, when loaded in an airplane equipped with the Dynon SkyView HDX system, will:
•
Configure all sensors to factory delivered values for the V35B. Edits may be required for
other engines. This would be accomplished manually using the Screen Layout Editor menu.
•
Locate all widgets in the EMS Bottom Band and 50% display to match the FAA Human
Factors assessed layout. This would be accomplished manually using the Screen Layout
Editor menu.
•
Configure the optional autopilot servos with the FAA approved values. This would manually
be accomplished using the Autopilot Setup menu.
Load the configuration file before you begin the configuration described in the configuration
manual. This will reduce the effort required.
The configuration manual and data file assume that the airplane is as delivered by the
manufacturer and has not been modified in any way. Any system or performance differences will
need to be manually configured after the configuration file has been loaded.
The configuration file can be downloaded to a USB drive and then loaded into SkyView following
the guidance provided in Section 2.
Where specific configuration selections or entries are required for certification, complete
instructions will be provided. The remaining configuration opportunities are considered
owner/operator-controlled options. Installers may need to consult with the owner/operator in
order to make the correct configuration selections.