24
Changing channel settings
DX-19LD150A11
3
Press
or
to highlight
Audio Only
, then press
or
to select
On
.
4
Press
EXIT
to close the menu. The picture turns off in
approximately 3 to 5 seconds.
Changing channel settings
Automatically scanning for channels
When you scan for channels, your TV/DVD combo
searches for channels available in your viewing area and
stores the channel information in the channel list. When
you press
CH
and
CH
, your TV/DVD combo tunes to
the next or previous channel in the channel list and skips
any channels that were not stored in the list.
You do not need to scan for channels if you are connected
using a cable or satellite box, which automatically
provides you with a channel list.
To automatically scan for channels:
1
Press
MENU
. The on-screen menu opens with the
Picture
menu displayed.
2
Press
or
to highlight
Channel
. The
Channel
menu opens. Press
or
ENTER
/
to access the
menu.
3
Press
or
to highlight
Air/Cable
, then press
or
to select your signal type.
You can select:
•
Air
—Select this option if you use an antenna.
Your TV/DVD combo scans for analog (VHF and
UHF) and digital channels in your area.
•
Cable
—Select this option if you have cable TV
and do not have a cable TV box. Your TV/DVD
combo scans for analog and digital channels in
your area.
•
Cable/Satellite Box
—Select this option if you
use a cable or satellite TV box. Your TV/DVD
combo will not scan for channels because the
cable or satellite TV box provides the channel list.
4
Press
or
to highlight
Auto Channel Search
,
then press
ENTER
/
.
5
A confirmation box opens. Press
or
to highlight
Yes
, then press
ENTER
/
to start the auto scan.
6
A progress box shows the progress of the scan.
Auto Scan may take a while to complete. A progress
report is displayed while your TV/DVD combo is
scanning for available channels. If you select
Air
,
after the digital channel scan is complete, you can
continue to search for analog channels without
pressing any buttons, or you can press
EXIT
to exit if
you do not need the analog channel scan.
You can press
MENU
or
EXIT
at any time to stop
scanning, but you must run the scan later to
complete the process.
Notes
•
Audio only works only when the input source is
TV and your TV/DVD combo is receiving a
broadcast signal.
•
To exit audio only mode, press any button.
When you exit audio only mode, the
Audio
Only
option is automatically reset to
Off
.
Note
You do not need to scan for channels unless the
available channels changed after you ran the
Setup
Wizard
. For more information, see “Turning on your
TV/DVD combo for the first time” on page 16.
DX-19LD150A11_11-0915_MAN_ENG_V4.book Page 24 Monday, August 29, 2011 8:29 AM
