Dyness A48100, Руководство пользователя

Страница: 14 / 26

A48100 Unit User Manual
11
3 Installation and Configuration
3.1 Preparation for installation
Safety Requirement
This system can only be installed by personnel who have been trained in the power supply
system and have sufficient knowledge of the power system.
The safety regulations and local safety regulations listed below should always be followed during
the installation.

All circuits connected to this power system with an external voltage of less than 51.2V
must meet the SELV requirements defined in the IEC60950 standard.

If operating within the power system cabinet, make sure the power system is not
charged. Battery devices should also be switched off
.

Distribution cable wiring should be reasonable and has the protective measures to avoid
touching these cables while operating power equipment.

when installing the battery system, must wear the protective items below:
The isolation gloves Safety goggles Safety shoes
Figure3-1
3.1.1 Environmental requirements
Working temperature: -20 ℃ ~ +55 ℃
Charging temperature range is 0 ℃ ~+55 ℃ ,
Discharging temperature range is -20 ℃ ~+55 ℃
Storage temperature: -10 ℃ ~ +35 ℃
Relative humidity: 5% ~ 85%RH
Elevation: no more than 4000m
Operating environment: Indoor installation, sites avoid the sun and no wind, no conductive
dust and corrosive gas.
And the following conditions are met:

Installation location should be away from the sea to avoid brine and high humidity
environment.
 The ground for product arrangement shall be flat and level.

N
o flammable explosive materials near the installation site.
 The optimal ambient temperature is 15
℃
~ 30
℃
 Keep away from dust and messy zones
3.1.2 Tools and data
Tools and meters that may be used are shown in table 3-1.
Table 3-1 Tool instrument
Name
Screwdriver
（
Slotted
、
Phillips
）
Multimeter
Torque wrench Clamp current meter
Diagonal pliers Insulation tape
Pointed nose pliers Temperature meter
Pliers to hold the wire Anti-static bracelet
Stripping pliers Cable tie
Electric drill Tape measure