DYNAWATT 4000, Руководство пользователя

Страница: 13 / 26

Choice of Belt
The power which is transferred via the belts depends upon the belt width, wrap-around angle,
the number of belts and the belt tension. The service life of a single belt system is considerably
less than that of a twin belt system.
DIA pulley Belt size Type Qty Max. output
65 mm 12.5mm 12.5 ESC toothed 1 2500 Watt
57 mm 9.5mm 9.5 ESC toothed 2 4000 Watt STANDARD
65 mm 12.5 12.5 ESC toothed 2 > 4000 Watt
50 mm Micro-V Micro-V 6 grooved 1 4000 Watt
Belt Pulley Alignment
Nothing is more important for the service life of a belt than the alignment of the generator
pulley and engine pulley. Both pulleys must be absolutely parallel and flush aligned. If a pulley
is positioned at an angle to or slightly behind the other this can lead at least to a material
related reduction in the useful life of the belt. In addition the belt may slip out of the grooves.
INSTALLATION
Generator Installation
Figure 9. The generator is fitted as an additional alternator. It must be securely and
permanently installed since the drive takes two to three times more power than factory-fitted
standard alternator. The ratio to be taken into account during installation is dependent upon
the engine idling speed and the maximum speed.
NOTE
All installation screws must therefore be secured using Loctite to prevent
accidentally working loose.
Fitting the generator cover
The generator cover must be positioned in such a way that the generator is able to take in dry,
cool air via the intake opening (DIA. 55 mm). If this is not possible then a
suction hose must
be connected to the opening to provide dry, cool air and must be fitted in an appropriate
position in the vehicle. The higher the air intake temperature the greater the heat related loss of
generator performance. See Figure 9.
13