FAQ FOR THE DYNAVIN N7-MST2010 PRO
FORD MUSTANG 2010-2014
N7-MST2010 PRO FAQ| © DYNAVIN NORTH AMERICA
8. Does the Dynavin support an aftermarket amp/speakers/etc. if I want to install in the future?
Yes. The Dynavin connects to all the factory wiring, but also comes with a full set of RCA amplifier outputs
(front, rear, sub) and A/V inputs and outputs
—
like any other aftermarket head unit
—
to support various
aftermarket equipment.
9. Can I install a backup camera to use with the Dynavin radio?
Yes. The Dynavin has a conventional composite video RCA input for a backup camera that will work with
almost any aftermarket camera. The install is the same as with any other aftermarket backup camera solution
except there is no reverse trigger wire necessary as it is already integrated into the Dynavin radio's main wire
harness. And, yes, it can also be integrated with your factory camera.
Click here for factory camera integration
“
Aftermarket Camera
”
under the
“
System
”
menu.
II. INSTALL
10. How do you install the iLink Pro dongle?
Simply plug in the iLink Pro dongle (included with all N7 PRO models) into the USB port labeled "iLink Pro" on
the back of the Dynavin radio. You can run the dongle to the arm rest to connect to your OEM USB plug
(adapter included) or if you don
’
t have the OEM USB port, you can run it to your glove box/compartment or
you can purchase the flush mount USB to install the USB port anywhere you prefer.
So it'll look something like this:
"iLink Pro" USB port at the back of the radio > "iLink Pro" dongle >
“
iLink Pro
”
3ft USB extension cable > Flush
Mount USB/OEM USB port
11. Will the Dynavin keep my factory USB and/or aux connections in the armrest?
Yes. The kit comes with retention cables for these two plugs. On Sync-equipped cars the factory USB
connection can be found on the Sync module above/behind the glove compartment. Use the supplied USB
retention cable to connect the matching factory plug at the Sync module to the “MEDIA” USB plug on the back
of the Dynavin. The aux connection is accessed in the center console right on the backside of the aux plug.
Unplug the factory cable and use the supplied aux retention cable to connect to the AUX IN RCA harness on
the back of the Dynavin.
12. Will the Dynavin radio work with my car's SiriusXM Satellite radio?
Satellite radio can be added to the Dynavin radio system by installing the Sirius SXV300 tuner plugged into the
supplied adapter cable. The factory satellite radio is not compatible with the Dynavin as it is part of the factory
audio system that is being replaced with the Dynavin. However, it is possible to use the factory satellite radio
antenna by using the "Maestro HRN-ANT-SAT1 FAKRA to Aftermarket SMB Satellite Radio Antenna Adapter"
with the SXV300 tuner. Make sure the Region is set to US in the System menu. Access SiriusXM from the Radio
menu by tapping the lower left box on the screen.
13. Will the Dynavin work with my Shaker amplifier?
Yes. On cars equipped with the Shaker amplifier, the amplifier integration harness
may
need to be used to
match the output of the Dynavin radio to the input of the stock amplifier. The harness goes between the RCA
outputs of the head unit and the signal wires on the main harness (plug B). If your audio is worse after
installing the amp retention harness, you likely don
’
t need it. See #21 for more.
