_____________________________________________________________________________________
Pagina 28
10: FAQ
1. When cannot change mode.
-. Check if the Ground (IR) cable is connected or not.
-. Check if LED lamp is turned on or not. If it is not turned on, Check if power cable is connected or not.
2. When the screen is displaying only black color.
-. Check if 2nd LED is turned on or not. If it is not turned on, please check all video sources that you
will connect with the interface is operating well or not.
-. Check if interface is connected well.
3. When displayed color of screen is not proper. (If it’s too dark or the color is not proper)
-. Try to select “Initial” on OSD menu, If the color of screen keeps on displaying wrong color, you
have to ask
Dynavin
for the problem.
-. Try to adjust Color, Contrast, Brightness by the remote.
4. When Back-up camera is not displayed on the screen.
-. Put Dip switch 7 down (ON).
-. Factory mode – rear select – must be in LAMP position
-.Grey wire is not connected with +12V rear gear signal
-. Grey wire does not get a good/stable rear gear +12V signal
5. When the mode you set is not skip.
-. Check if Dip switches is set properly.
6. When Main screen on the car is not displayed.
-. Check if In/Out cables are connected well. If it keeps showing the same problem, you have to
ask
Dynavin
for the problem.
7. When the screen is displaying only white color.
-. Check if out cable is connected well.
8: The image of the camera is vibrating?
- Check the power supply of the camera system. Make extra ground to the camera power supply.
