20
Connecting loudspeakers
In home cinema systems the bass
management - meaning the distribution
of the low frequencies to the subwoofer
and the speakers - is handled by the
settings of the processor/receiver. If
your equipment does not provide bass
management, or if you want to use the
Sub 3 together with a common stereo,
the low frequency adjustment of the
connected speakers can be managed
by the Sub 3. This not only improves
the sound by matching subwoofer and
speakers, but also by freeing the power
amplifier and connected speakers from
the effects of sound-compromising bass
reproduction. Also refer to the further
explanations in the chapter “Connecting
the subwoofer” on page 10.
To connect speakers:
1.
Connect the subwoofer with the
processor/receiver as explained in
“Connecting a single subwoofer” on
page 18.
2.
From the Subwoofer
SAT Output
connect a RCA cable to the
Main
In
of the power amplifier you use for
your speakers.
ON
AUTO
GAIN
PHASE
POWER
SUB Lowpass
SAT Highpass
SAT/SUB Input
SAT Output
LFE / Slave IN
OUT
Min
Max
50Hz
150Hz
0° 180°
LEFT
RIGHT
SUB I/O
To Slave
LFE
Slave
60Hz
Flat 80Hz
Note
Stereos do not have a LFE channel. In this case just connect the front outputs of
the processor/receiver (Front Out/Pre Out) with the subwoofer.
The signals connected to the
SAT/SUB Input
are provided at the
OUT - To
Slave
output for connecting another subwoofer. See page 19 to learn more about
connecting multiple subwoofers.
1.
2.
ave
of
out
Содержание Sub 3
