Dynaudio Excite X14A, Руководство пользователя

Страница: 8 / 12

Operation
6
Setting up
1/2. Power on/off switch / AC power in
Before switching on, make sure Mains
Voltage matches your areas Mains Voltage
specification.
3. Balanced analog input
Audio Input is via a fe-
male XLR connector.
The input is electroni-
cally balanced with fol-
lowing connections. The connections are
printed on the rear for easy reference.
4. Unbalanced analog input (RCA)
Unbalanced Input via RCA. If your
audio source doesn’t have a balanced
output use the RCA input connection.
For best results always use only good qual-
ity screened cables and connectors.
Switches
On the rear of the speaker you will find six
switches for setting up the speaker for
optimum performance in different acoustic
environments. Each switch is explained in
the following.
5. Power mode switch
ON:
The speaker is active and ready to
play.
ON/SLEEP: If no input signal has been
present on the input for 20 minutes, the
speaker enters “Sleep” mode and saves
power. The speaker is invoked and ready
to play when a signal is present on the in-
put again. Wake-up time is approximately
two seconds.
7. Filter switches
LF:
This switch controls the bass gain level
using shelf-type EQ. The level can be set to
+2 dB, 0 dB or -2 dB.
This filter is used to adjust for the prox-
imity of boundaries, so if positioned close
to wall or corner, use the -2 dB setting.
If positioned far from walls use the +2 dB
or 0 position, depending on other
equipment,
and personal taste.
MF: This switch sets a notch filter,
used to compensate for the acoustic
effect of a console.
Such placement usually results in a re-
sponse peak in lower midrange. The MF
switch activates a bell shaped notch
filter, which can compensate. Use either
the -2 or the -4 dB setting. Finding the
setting that provides the flattest response.
HF: This switch controls the Treble
level and it is used to match the high end
of the monitor to your other electronic
equipment,
and your acoustical
environment. Use the setting providing
the preferred timbre. If the sound is too
bright; try to set to -1 dB to reduce treble
by 1 dB. If the sound is too dull, use +1 dB
setting to raise the High Pass by 1 dB.
HP: This switch sets the lower cut-off
frequency of the speaker. It is used to
match the speaker to a subwoofer. You
can select between 60 Hz or 80 Hz X-
over. Flat is used in case you do not
use a subwoofer
1 : 0
2 : +
3 : -
3
1 2