Dynatech SD-BOX, Инструкция по эксплуатации и техническому обслуживанию

Страница: 8 / 28

SD-BOX INSTRUCTION MANUAL, CODE: DYN 81.01.00
Date: 03/03/2020
Version 00
- 7 -
The following steps are needed to activate the MANUAL TRIPPING mode:
o
Press the “MODE” and “MANUAL TRIPPING” buttons simultaneously for 3 seconds until the
number 55 appears on the display.
o
Press
(▲)
20 times until the number 75 appears. Press “MODE” and the MANUAL
TRIPPING LED lights up indicating this option is activated.
o
When the “MANUAL TRIPPING” button is pressed, the overspeed governor is locked.
o
When the “MANUAL TRIPPING” button is released, the overspeed governor is unlocked.
o
To disable the MANUAL TRIPPING mode and return to normal status, press the “MODE”
and “MANUAL TRIPPING” buttons at the same time. It can also be disabled by pressing the
“RESET” button.
To configure the de-energisation wait time at the floor level, follow the instructions in section “ 6.2
SETTING THE COIL DE-ENERGISATION WAIT TIME WITH THE CAR AT LEVEL ”.
To configure the FAILURE output relay, follow the instructions in section “ 6.3 SETTING THE
FAILURE OUTPUT RELAY ” .
LED indicators
•
POWER: Flashes when the SD-BOX is receiving power externally or from the batteries.
•
STAND-BY: When the SD-BOX is in low consumption mode with the display and LEDs off.
•
BATTERY CHARGING: Indicates the battery charging status: “Off” if it is charged, “on” if it
is charging and flashing when checking the battery status.
•
BATTERY FAILURE: “Flasing” indicates a battery fault (damaged and impossible to charge)
or battery disconnection.
•
FAILURE CONFIG.: Indicates the FAILURE output relay setting: “Off” indicates the SD-BOX
will act on the relay if it detects any fault or error, and “on” indicates the SD-BOX will act on
the relay according to the coil status. FAILURE output is a non-safety related signal.
•
MANUAL RESCUE/BY PASS: “On” indicates the coil is being powered manually by
performing a rescue manoeuvre.
•
MANUAL TRIPPING: “On” indicates the manual locking function is active and will manually
lock the overspeed governor when the “MANUAL TRIPPING” button is pressed.
•
UCM DETECTED: “Flasing” indicates the system has detected unintended movement of the
car (UCM). The safety line contact will open and the fault “F2” will appear on the display.
•
DOORS: “On” indicates the door series is closed. If it is flashing, there is a discrepancy in
the internal DOORS1/DOORS2 signals.
•
MOTOR: “On” indicates the motor is running.
•
LEVEL1: “On” indicates the car is at floor level.
•
LEVEL2: “On” indicates the car is at floor level.
•
INDUCTOR/μSWITCH
: “On” indicates the unlocking sensor detects the overspeed governor
is unlocked.
Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer
area in Dynatech’s website in order to consult the full manual; http://customers.dynatech-elevation.com/