INSTRUCTIONS : PR-2500-UD Cod : DYN 05.01.08
Date: 15/04/2016 Revision: 08
6
Figure 5: Roller position
Figure 6: Roller position on inverted guide rails
During assembly, the safety gear should be perfectly aligned with the guide rails, both vertically and
horizontally. Improper assembly may cause the safety gear to function incorrectly.
Figure 7: Improper assembly
3.2 SAFETY GEAR ADJUSTMENT
The guide rail's position in the block should be adjusted as follows: The side of the guide rail 1.5 mm from the
brake shoe; the head of the guide rail 3 mm from the back of the groove (see drawing DYN 05.C001.01 / DYN
05.C002.01).
⚠
In order to avoid problems with the installation’s normal operation, it is very important that the person
carrying out the installation rigorously observes the distances mentioned in this item.
⚠
It should be checked that the safety gear is placed so that the rollers for downwards jamming, marked
with the letter “D”, are on the bottom part of the safety gear, as is shown in item 3.1.
