English - 14 -
Signal strength at RX and power level at TX.
Squelch level.
Volume level.
VFO mode operation.
Keypad locked.
The current band is prohibit to TX & RX.
6.3.- REAR PANEL:
(1) ANT:
External antenna connected to this terminal. During the transmitting test, connect the load to replace
the antenna. Antenna system or the load should be with 50 Ω impedances.
(2) Heat sink:
Allows cooling avoiding overheating that can cause damage to the internal components of the
transceiver.
(3) External power plug:
When you connect to the external power, you should carefully check the polarity of the power
supply (Red cable: + and black cable: -) and the power ratings (13.8 VDC ±15 %).
(4) Rack mounting screws:
Release the left and right screws to adjust a proper position angle, and re-fasten.
[SP/MIC] jack on side panel:
If necessary, connect a suitable headset or an external speaker for better sound. In these jacks can
only be connected monaural jacks with 2.5 mm and 3.5 mm diameter socket.
