background image

 

 

 

English - 9 -

 

 

Note: 
-  Consult with  your salesperson to program  the  “CTCSS” tones  and  “DCS”  codes  on your 
transceiver. 

 

8.12.- BATTERY SAVE: 

 
This  function  decreases  the  battery  consumption  when  no  signal  is  being  received  and  operations 
are not performed on the transceiver (keys and controls are not used). While the channel is not busy 
and no operation is performed on the transceiver for 10 seconds, the battery save function will be 
turn  ON.  When  a  signal  is  received  or  any  operation  is  performed  on  the  transceiver,  the  battery 
save function will turns OFF. 
 

8.13.- SCAN FUNCTION: 

 
The transceiver will scan the 16 channels to search a busy channel. With the programming software 
you can configure the scanning by carrier or by time. 
Carrier Scan: The transceiver will scan the channels and stop on an active channel until the signal 
disappears. 
Time scan: The transceiver will scan the channels and stop on an busy channel for 5 seconds, after 
which time the scan will resume automatically. 
 

8.14.- LOW BATTERY ALERT: 

 
If  the  battery  charge  is  low,  the  transceiver  will  sound  a  warning  beep  (can  be  set  by  the 
programming software). 
 

8.15.- SCRAMBLER FUNCTION: 

 
This is another voice encryption different from  “CTCSS” tone or “DCS”  code. With this function 
enable,  the  transceiver  will  transmit  the  signal  +  the  encryption  code  and  the  other  user  must  be 
enabling  this  function  previously  they  can  communicate  with  clear  voice.  This  function  can 
program by programming software. 
 

8.16.- COMPANDER FUNCTION: 

 
This function minimizes background noise when receiving a signal; it is very useful in long distance 
communications or background noise environments. 
You can activate this function by the programming software. 
 

9.- TECHNICAL SPECIFICATIONS: 

 

Frequency range: 

 

 

446.00625 MHz to 446.09375 MHz (Tx/Rx). 

Channels number: 

 

 

16 (8 + 8). 

Channel separation:   

 

12.5 kHz. 

Antenna type:  

 

 

Integral. 

Transmission power (E.R.P.): 

500 mW. 

Modulation:   

 

 

FM (F3E). 

 

Maximum deviation:   

 

±2.5 kHz. 

Frequency stability:   

 

±1.5 ppm. 

Sensitivity: 

 

 

 

<6.0 dBμV. 

Spurious emissions:   

 

<-60 dB. 

Содержание L88











Отзывы: