COMMODE ASSEMBLY
ADJUSTING LEG HEIGHT
1. Attach the Bucket Frame to the Armrest Assembly by
depressing the brass push button on the Bucket Frame and
sliding it into the corresponding hole in the Armrest
Assembly. Ensure the push button is fully engaged through
the hole. Make sure the back of the Bucket Frame (the back
of the Bucket Frame has the barcode sticker) corresponds
to the back of the Armrest Assembly (the back of the
Armrest Assembly has the back rest receptacle).
2. Attach the Frame Support Bar to the Armrest Assembly by
depressing the brass push button on the Frame Support Bar
and sliding it into the corresponding hole in the Armrest
Assembly. Ensure the push button is fully engaged through
the hole.
1. Before use, adjust height of each leg to your specific needs,
making sure all legs are at the same height. When desired
height is reached, lock legs into place by aligning buttons
into proper holes.
2. Make sure legs are locked into place by pushing down on or
pulling legs.
INSTRUCTIONS
1. To operate the drop arm, push the lever forward to release
and slowly lower the arm so it rests against the bar at the
bottom of the frame. To return the arm rest to the upright
position, lift the arm up until the lever latch clicks into place.
CAUTION:
Do not lean or push down on the arm rest until the
latch has been checked to insure the latch is in place and will
hold weight.
2. Arms should be unlatched and dropped to assist in transfer
onto/off the device.
3. To remove the toilet seat and lid, first remove the lid by
grasping the lid near the clamps and pulling away from the
back rail of the Bucket Frame. Repeat for the seat.
4. Attach the Backrest to the Backrest Receptacles in the
Armrest Assembly by depressing the brass push button on
the Backrest and sliding it into the corresponding hole in the
Backrest receptacles. Ensure the push button is fully
engaged through the hole.
5. Align the Toilet Seat to the opening in the Bucket Frame
and the Toilet Seat clamps to the back rail of the Bucket
Frame. Push down on Toilet Seat until clamps snap firmly
into place. Repeat for the lid.
6. Insert Commode Bucket into the brackets of the Bucket
Frame.
3. Repeat steps 1 and 2 to attach the Bucket Frame and Frame
Support Bar to the other Armrest Assembly.
Bucket
Frame
Armrest
Assembly
Frame
Support
Bar
