Dynapac F1250CS, Приложение, эксплуатация и обслуживание

Страница: 236 / 348

D 40.12 26
When work is finished
- Run the paver finisher empty and stop it.
- Move the drive lever (1) to the central position, set preselector (2) to "0" and set the
speed adjuster (3) to minimum.
- Switch the auger (4), conveyor (5), tamper (6), vibration (7) and levelling (8) func-
tions to "OFF".
- Lift the screed with switch (9).
- Insert the screed transport safeguard.
- Retract screed to basic width with switch (10).
Where applicable, completely extend the levelling cylinders using switch (11).
- Use switch (12) to close the hopper lids.
- Insert the hopper transport safeguards.
- Set tampers (6) to "manual"; while operating the tampers at a low speed, let any
material residues which have penetrated drop out.
- Switch tampers (6) to "OFF".
- Switch off screed heater (13).
- Switch the working and warning lights (14) to "OFF".
- Switch off the drive engine (15)
- Read and check the operating hour meter (16) to determine whether maintenance
work must be performed (see chapter F).
- Switch off the ignition (17).
- Close the main shut-off valves and the bottle valves for the screed gas heating sys-
tem (
o
).
- Remove the levelling units and stow them away in the boxes, close all flaps.
- Remove all parts that extend beyond the paver finisher contour or secure them if
the paver finisher is to be transported over public roads on a low-bed trailer.
m Do not turn off main switch until 15 seconds after the ignition has been turned off!
A
The engine electronics need this length of time to back up data.
- Cover and lock the operating panel.
- Remove material residues from the screed and the paver finisher and spray all
parts with separator fluid.