Dynapac CA 302, Инструкция по эксплуатации

Страница: 110 / 121

Maintenance - 1000h
ICA302-4EN4.pdf 2012-04-12
Clean thoroughly around the oil filters.
Fig. Engine compartment
1. Hydraulic fluid filter (x2).
1
Remove the oil filters (1) and dispose of them in
an approved manner. They are single-use filters
and cannot be cleaned. Remove the oil filters (1) and dispose of them in
an approved manner. They are single-use filters
and cannot be cleaned.
Make sure that the old sealing rings are not left
on the filter holders, as this could cause leakage
between the new and old gaskets. Make sure that the old sealing rings are not left
on the filter holders, as this could cause leakage
between the new and old gaskets.
Thoroughly clean the sealing surfaces of the filter
holders.
Apply a thin coat of fresh hydraulic fluid to the rubber
gaskets on the new filters. Screw on the filter by hand.
First tighten the filter until its seal is in contact
with the filter attachment. Then turn an additional
half revolution. Do not tighten the filter too hard
as this could damage the gasket. First tighten the filter until its seal is in contact
with the filter attachment. Then turn an additional
half revolution. Do not tighten the filter too hard
as this could damage the gasket.
Start the engine and ensure that there is no leakage of
hydraulic fluid from the filters. Check level of fluid in
the sight glass (3) and top up as required.
Ensue that there is good ventilation (air extraction)
if the engine is run indoors. Risk of carbon
monoxide poisoning. Ensue that there is good ventilation (air extraction)
if the engine is run indoors. Risk of carbon
monoxide poisoning.
Hydraulic reservoir - Draining
Fig. Underside of hydraulic reservoir
1. Drainage tap
2. Plug
1
2
The condensate from the hydraulic reservoir is drained
through the drainage tap (1).
Drain the roller after it has been stationary for a long
time, e.g. after standing overnight. Drain as follows:
Remove the plug (2).
Place a container under the tap.
Open the tap (1) and let any trapped condensate run
out.
Shut the drainage tap.
Refit the plug.
100