SIMPLE BY DESIGN – FLEXIBLE IN APPI\LICATION
730 – 11731 BAYNES ROAD, PITT MEADOWS, BC, CANADA, V3Y 2B4
PHONE: 604-465-0009
WEB PAGE:
www.dynanav.com
EMAIL:
FAX: 604-465-0084
3
8. Change Swath Width – Button the allows the pilot to change the Swath Width.
9. Reset or Clear – resets timer and saved application.
10. Working Mode Toggle Button - AUTO = Flow controller will adjust the flow. MANUAL = Valve will
remain fully open, and the pilot can adjust manually the flow with the by-pass.
11. Pressure Sensor - Displays the reading of the pressure sensor.
12. Swath Width – Displays the current Swath Width being used.
13. MORE… Button – MORE SETTINGS - Gives options for the system. See Below
14. FLOW Button – FLOW SENSOR AND VALVE page - Gives the Pilot the options for Which Flow
System he has installed, such as Electric Flow Valve or Hydraulic Motor driven Pump as well as
Calibration entr. Also, the Flow Motor can be tested and the Flow Meter reading can be seen here.
15. GPS Button – GPS RADIO RECEIVER - Gives the Pilot the number of satellites in use. (GPS +
G WAAS) as well as to set the clock for local time or Universal time.
16. PRESSURE Button – PRESSURE SENSOR AND RELAY - To set the boom pressure required for
marking of the GPS System for As Applied Maps. This setting also tells the Flow Valve Motor to stop
below this number and to go active for control of the flow above this number.
17. HOST DEVICE Button – COMMUNICATION - For setting the system between DynaFlow Standalone
or communications from an External GPS system to set flow parameters. If Host is available, it will
automatically update the Swath Width, Speed and Rate.
18. SHUTDOWN – When finished application- be sure to use this button to Shutdown the DynaFlow 2
before turning off the aircraft Master Switch.
