DynAmp RCEM, Инструкция по установке, эксплуатации и обслуживанию

Страница: 64 / 78

Installation, Operation and Service Manual RCEM
© 2012 DynAmp, LLC Page 50
43756 G
c. Click on the SCAN “START” button. The cursor will change to an hourglass and data
will be acquired and displayed continuously at the scan rate.
CAUTION
Do not turn RCEM DAU power off when SCAN mode is active. The
computer may lose communications with the RCEM DAU. See
“ Recovering from DAQ Errors ” below to correct problem.
B.12 STOPPING THE SCAN MODE OF OPERATION
Uses the following procedures to stop the rectifier data scan:
1.
Move the hourglass shaped cursor over the SCAN “STOP” command button.
2. Click on the SCAN “STOP” command button.
3. The rectifier data scanning will stop and the cursor shape will change.
4. The keyboard key combination of “CNTRL+SHIFT+S” will also end the SCAN mode
of operation.
B.13 VIEWING THE DIODE CURRENT BAR GRAPHS
See Figure B.5 for a typical diode current bar graph. Use the following procedure to view the
diode current bar graphs:
a. Start the SCAN Mode of operation.
b. Move the hourglass shaped cursor over the desired leg worksheet tab.
c. Click on the selected leg worksheet tab.
d. Click on the “Display” worksheet tab to switch back to the “Display” screen.
B.14 RECOVERING FROM DAQ ERRORS
Use the following procedure to recover from the error:
1.
Disconnect the USB cable. All LEDs except the “24V P.S.” LED should turn off.
2. Click to clear the DAQ Error Message Box.
3. Click to clear the Visual Basic Error Message Box.
4. Exit from the Excel spreadsheet.
5. Reconnect the USB cable.
6. Restart Excel spreadsheet. If the program inquires whether you want macros
enabled, select “Enable Macros”.
7. A message box will appear with the following message: ”Personal Daq is not
running. Do you wish to start the Personal Daq?”
8. Click on the “No” button.