After entering the password, you can access main page of your switch.
3.2 Console Management (Out-of-band)
A local console is a terminal or a workstation running a terminal emulation program
that is connected directly to the switch via the RS-232 console port on the rear of the
switch. Local console management uses the terminal connection to operate the
console program built-in to the Switch a network Administer can manage, control and
monitor the switch from the console program.
To start using the Console Management program, first connect an EIA-232 serial
cable to a COM port on a PC or notebook computer and to the Console Port on the
rear panel of the Switch.
If you are using Microsoft Windows, boot up the computer, go to
“Start”-“Programs”-“Accessories”,-“Communications”, and open the
“HyperTerminal”. After that follow the instructions below to setup a new terminal
connection software, please select the correct COM port and setup the connection
properties according to step 3 below.
1. Type in a name for the connection, select an icon for the connection, and click
“
OK
”
.
2. Select the COM port that you are using for this connection and click
“
OK
”
.
3. Setup the COM port properties by using the information below and click
“
OK
”
.
NOTE:
The console port is set at the factory for the following configuration:
Baud rate: 115200 bps
Data width: 8 bits
Parity: none
Stop bits:1
Flow Control: None
Dynamode Ltd
