12
Figure 11
E. Installing the FLOOR EMITTER PANEL (Carbon Models Only), BENCH EMITTER PANEL,
BENCH, and REAR PANEL GRID (Ceramic Models Only)
1. If your model is not equipped with the FLOOR EMITTER PANEL, then skip to 2. If your model
is equipped with the FLOOR EMITTER PANEL, then place it on the floor towards the front of
the sauna. (see figure 12 - 13)
Figure 12
Figure 13
2. Slide down the BENCH EMITTER PANEL by lining up its sides with the vertical guides on
each side panel. The emitter grid will face outward (toward the front of the sauna). Push the
BENCH EMITTER PANEL all the way down until it is touching the FLOOR PANEL and is
secured in place.
3. Plug in the BENCH EMITTER connector to the inlet located on the REAR PANEL.
4. Install the BENCH by sliding it over the horizontal bench guides on the side panels. Push the
BENCH all the way in until it touches the REAR PANEL and is secured in place. Make sure to
install the BENCH with the smooth and finished side facing up. (see Figure 14)
