7
Pressing
at any time during configuration will prompt you to save the changes.
Select “Yes” to save any changes made. Selecting “No” will not save changes.
Configuration of “Hourmeter Settings”
Using the arrows on the keypad, select the “Hourmeter Settings” icon.
The first screen will allow you to configure the hourmeter to either count up or count down by
pressing the up / down arrows to select, then pressing the right
arrow to navigate to the
next screen. Here, you will be able to either leave the hourmeter to the current setting or pre-
select any number up to 99999 hours. Following this, you will be asked to save the changes.
Configuration of “Alarm Settings”
Using the arrows on the keypad, select the “Alarm Settings” icon.
Here, you can either enable or disable the RPM Alarm and select both underspeed (RPM
Alarm Low) and overspeed (RPM Alarm High) setpoints. Note that if underspeed is not
required, the parameter should be set to “0.” The next screen to the right will allow
configuration of the “Hourmeter Alarm” if required. This will allow you to preset an hourmeter
value that may be used to alert the user of maintenance required, for example.
System Settings
Using the arrows on the keypad, select the “System Settings” icon.
There are (2) display layouts available, either “Large RPM Digit” or “RPM + Hourmeter.”
Note that you are selecting the default layout type. You will be able to change the layout
during normal operation by pressing the left / right arrows.
After setting the layout type, pressing the right arrow will allow the user to either enable or
disable a “Security Option.” The security option allows the user to set a 4-digit security code
for locking out the programming function. If this is not required, select “Disable” and press the
right arrow. You will then be asked to save any changes.
If you would like to enable the security option, select “Enable” and press the right arrow. The
next screen will allow configuration of any 4-digit security code from 1000 to 9999. Pressing
“Enter” will allow the code to be set. After pressing the right arrow, you will be asked to save
the new settings.
Note that if the security code is enabled, the display will always ask the user to enter the 4-
digit code if the “Menu” key is pressed.
In case the security code is mis-placed or forgotten, there is a master code for gaining access to the programming function. The master
code is “5034381”
To order call 1-800-548-1191 or visit www.partdeal.com - [email protected]