Dynacord PROMATRIX 8000 Series, Руководство пользователя

Страница: 4 / 34

14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
15. Do not expose this equipment to dripping or splashing and ensure that no objects filled
with liquids, such as vases, are placed on the equipment.
16. To completely disconnect this equipment from the AC Mains, disconnect the power
supply cord plug from the AC receptacle.
17. The mains plug of the power supply cord shall remain readily operable.
IMPORTANT SERVICE INSTRUCTIONS
CAUTION: These servicing instructions are for use by qualified personnel only.
To reduce the risk of electric shock, do not perform any servicing other
than that contained i n the Operating Instructions unless you are
qualified to do so. Refer all servicing to qualified service personnel.
1. Security regulations as stated in the EN 60065 (VDE 0860 / IEC 65) and the CSA E65 - 94 have
to be obeyed when servicing the appliance.
2. Use of a mains separator transformer is mandatory during maintenance while the appliance
is opened, needs to be operated and is connected to the mains.
3. Switch off the power before retrofitting any extensions, changing the mains voltage or the
output voltage.
4. The minimum distance between parts carrying mains voltage and any accessible metal piece
(metal enclosure), respectively between the mains poles has to be 3 mm and needs to be
minded at all times. The minimum distance between parts carrying mains voltage and any
switches or breakers that are not connected to the mains (secondary parts) has to be 6 mm
and needs to be minded at all times.
5. Replacing special components that are marked in the circuit diagram using the security symbol
(Note) is only permissible when using original parts.
6. Altering the circuitry without prior consent or advice is not legitimate.
7. Any work security regulations that are applicable at the locations where the appliance is being
serviced have to be strictly obeyed. This applies also to any regulations about the work place
itself.
8.
All instructions concerning the handling of MOS-circuits have to be observed
.
NOTE: SAFETY COMPONENT (MUST BE REPLACED
BY ORIGINAL PART)
WEEE RECYCLING/DISPOSAL INSTRUCTIONS
The Wheelie Bin symbol found on the product or in the manual indicates that
this product must not be disposed of with other waste. It is in our category the
manufacturer’s responsibility to properly dispose of their waste electrical and
electronic equipment (WEEE) at the end of its life. Due to the differences in
each EU country’s management of WEEE, please contact your local
distributor. We are committed to facilitate our own electronic-waste-
management-system, for the free of charge return of all EVI Audio GmbH
products: Telex, DYNACORD, Electro-Voice and RTS. Arrangements are
made with the dealer where you purchased the equipment from, for the
returning of all unusable equipment
at no cost , to the factory in Straubing, for
environmental protective disposa