S2x3BT
SSD
CN1910
To avoid damage, always hold the SSD only by its sides.
To prevent the SSD from being distorted when installing the SSD pack into the
computer, do not press the center of the SSD pack. Always hold the SSD pack by
its sides.
1. Remove the following screw and disconnect the
SSD
from the
connector
CN1910
on the SYSTEM board.
Figure 4-32 Removing the SSD
4.23.2 Installing the SSD
To install the SSD, follow the steps below and refer to
Figure 4-33
.
1. Insert the
SSD
to the connector
CN1910
on the
System Board
(FUR3SY*)
slantwise.
2. Push down the
SSD
and secure it with the screw.
Take care not to press on the top or bottom of a SSD. Pressure may cause the data
loss or damage to the device.
Содержание PORTEGE X40-G
Страница 7: ......
