Dyna-Fog CYCLONE ULTRA 2734, Руководство по эксплуатации и обслуживанию

Страница: 12 / 20

12 | P a g e
MAINTENANCE
1. Periodically clean the formulation tank using a hot water/detergent solution. Fully
open the machine valve and operate the machine for 3 to 5 minutes, flushing the
solution through the valve, lines and nozzle.
2. Examine the electrical cord for evidence of damage and replace any damaged cord
immediately.
3. After 400-500 hours of operation, carefully remove the blower assembly and
examine the brushes and the commutator bars of the blower motor. If brushes are
worn out, replace them. If commutator bars are damaged, replace Blower
Assembly.
4. If it becomes necessary to disassemble the Machine Flow Valve for cleaning, be
careful not to enlarge the metering orifice or damage the taper of the valve steam,
as this will affect the calibration of the machine.
5. Clean the Air Intake Filter after every application. If the filter gets saturated (wet and
dripping) while the machine is working, stop the machine and clean the filter.
Note : If it becomes necessary to operate the machine in areas where the air become
saturated with spray droplets and these droplets accumulate at the blower intake filter,
the machine can be outfitted with an optional “Fresh Air Intake Hose” P/N 62060.
To repair the blower/motor components and request spare parts, please see section
“”Rotary Fan Replacement”.