12
U S E R G U I D E
|
U V C S S I D E CU R E C O N V E Y O R
Maintenance
Belt-Tracking Adjustment
All Dymax UVCS Conveyors are factory adjusted to provide proper tracking of the Belt. Should further adjustments become
necessary, this is done via two knurled Adjustment Knobs located at the input end of the Conveyor (Figure 12). To adjust
tracking, simply tighten the side to which the Belt is tracking.
NOTE: Do not over tighten the Belt. This will lead to accelerated degradation of the Belt.
Figure 12.
Belt-Tension Adjustment Knob
Conveyor Belt Replacement
1.
Remove the Pinch Guard from the Motor side of the Conveyor by removing the two M4x8 Screws (Figure 13) on the
front side of the Conveyor and the M4x25 Screw (Figure 15) from the motor drive side of the Conveyor. Remove the
motor box cover (Figure 14) to obtain access to the M4x25 Screw.
Figure 13.
M4x8 Screws
Figure 14.
Remove Motor Box Cover
Figure 15.
M4x25 Screw
2.
Remove all tension from the Belt by fully backing off the Belt-Tension Adjustment Knobs (Figure 12).
3.
Position the Belt Splice to the end of the Conveyor (Figure 16). Remove the Fiberglass Rod that ties the ends of the
Belt together (Figure 17). Remove the Belt.
