10
Dymax ECE ZIP™ Shutter User Guide
ECE 2000 Flood Lamps
NOTE: If the ZIP Shutter and Lamp Assembly are NOT installed into a Light Shield, the Glass Containment Shield
must be installed.
1.
Install the Glass Shield (if applicable) (Figure 10).
2.
Install the ECE 2000 Mounting Plate on the base of the ECE 2000 Lamp Housing (Figure 11) by installing
the M4 x 8 mm screws.
3.
Install the Glass Shield (if applicable).
Figure 10. Reflector Housing with Glass
Shield Installed
Figure 11. Lamp Housing with
Mounting Plates Installed
4.
Install the Lamp Housing Assembly into the ZIP™ Shutter and attach it with four M4 x 8 mm screws
(Figure 13).
NOTE: One side of the Mounting Plate has a third screw hole (Figure 12). When in the correct position, this
screw hole will be at the rear of the Shutter.
Figure 12. Lamp Housing Assembly
Figure 13. ECE 2000 Lamp Housing
Assembly Installed with M4 x 8 Screws
Four M4 x 8 screws (two located on opposite side)
Third Screw Hole