W
W
W
.
R
O
T
O
R
L
O
A
D
E
R
.
C
O
M
R O T O R
™
L O A D E R O W N E R ’ S M A N U A L
SPECS
.
CAPACITY:
200 paintballs
FEED RATE:
50+ bps
WEIGHT:
1.3lbs (empty with batteries)
DIMENSIONS:
4.75”H x 8.5”L x 4.25”W
POWER SUPPLY:
Three AA batteries
U.S. and International Patents Pending.
• Misuse of paintball equipment may
cause serious injury or death.
• Please read, understand and follow
the directions in the Rotor Loader
owner’s manual.
• Eye protection that is designed
specifically for paintball and meets
ASTM/CE standards must be worn
by user and persons within range.
• Recommend 18 years or older to
purchase. Person under 18 must
have adult supervision.
• If you read these instructions and
do not fully understand them or are
unsure of your ability to make
necessary adjustments properly,
call DYE or your local pro shop
for help.
IMPORTANT SAFETY INSTRUCTIONS
AND GUIDELINES.
W A R N I N G
QUICK SET-UP GUIDE
BATTERY INSTALLATION
No tools are required for battery installation, just follow the simple instructions found on
page 2. Three AA batteries are required to operate the Rotor Loader. When installing the
batteries make sure to install them the correct way by following the + and - polarity
markings on the battery holder.
MOUNTING ROTOR LOADER ON A MARKER
Make sure the Rotor Loader is securely mounted on you marker's
feedneck and the Rotor Loaders feed tube is bottomed out on your
marker's feed neck.
It is recommended to use an adjustable clamping feed neck system
with the Rotor Loader.
Do not over tighten your marker’s feed neck on the Rotor Loader as
it may damage the Rotor Loader.
TURNING THE ROTOR LOADER ON/OFF
Once the batteries have been installed and the Rotor Loader is fully
assembled, simply press the power button at the rear of the Rotor
Loader (see figure
1a
). As soon as the LED light indicator
comes on, the loader is ready to go.
There is no programming or boot up sequence to worry about,
just load up paintballs and go.
IF ROTOR LOADER JAMS PAINT
In the unlikely event that the Rotor Loader jams paint,
simply give the jam release trigger a quick pull.
This will turn the center rotor arm in reverse, quickly
clearing the jam. The jam release trigger is located on the
underside of the Rotor Loader (see figure
1b
).
WARNING: RESULTS MAY VERY DEPENDING ON THE
QUALITY OF PAINTBALLS USED WITH THE ROTOR LOADER.
Figure 1a
W
W
W
.
D
Y
E
P
A
I
N
T
B
A
L
L
.
C
O
M
1
Figure 1b
