D3000
Series
–
User
Manual
–
D3000
‐
USER
‐
EN/09F/v2
‐
7
Resetting the system after an alarm
Enter your user code followed by the [OK] key (or place your tag against the keypad). If the
display returns to the normal unset message, then no further action is necessary.
Otherwise, contact your Alarm Company.
The following features may not be enabled for your system.
Please consult your Alarm Company for further information.
Setting the system with zones omitted
Enter your user code followed by the [
menu
] key (it is not possible to use tags for this). The
display will now show “Set or unset groups”, press [
OK
] and the display will indicate which
groups can be set. Select some or all of the groups as required.
Note: “
u
” and “
s
” on the display show that the group is unset or set; “
U
” or “
S
” indicates that
you are about to change the group to unset or set. Press [
OK
] to continue.
The display will now show the zone reference for the first zone that can be omitted. Move up
and down through all the omitable zones using the [
↑
] and [
↓
] keys, pressing the [
0
] key to
omit it or the [
1
] key to activate it. Press [
OK
] to start the setting mode. If a detector is
active at this point, the system will return to the unset condition. Simply start exit mode
again, the system will remember which zones are omitted.
Personal attack (PA)
Press a PA button to set off the alarm.
Enter your user code followed by [
OK
] to silence the alarm. The display will show the zone
that generated the alarm.
To reset the alarm condition, re-enter your user code followed by [
OK
].
Fire
If a smoke detector activates, the alarm will sound with a different tone to normal.
Enter your user code followed by [
OK
] to silence the alarm. The display will show the zone
that generated the alarm.
To reset the alarm condition, re-enter your user code followed by [
OK
].
