Dyaco XT660B-A912, Руководство по обслуживанию

Страница: 64 / 83

S S e e r r v v i i c c e e M M a a n n u u a a l l
-63-
10.2. Service Troubleshooting Checklist – Diagnosis Guide
Before contacting your dealer for aid, please review the following information. It may save you both time and expense. This list includes common
problems that may not be covered under the treadmill’s warranty.
PROBLEM SOLUTION/CAUSE
Display does not light 1) Tether cord not in position.
2) Circuit breaker on front grill tripped. Push circuit breaker in until it locks.
3) Plug is disconnected. Make sure plug is firmly pushed into
110VAC(for 110V model) or 220VAC(for 220V model) wall outlet.
4) Breaker panel circuit breaker may be tripped.
5) Treadmill defect. Contact your dealer.
Tread-belt does not stay centered The user may be walking while favoring or putting more weight
on either the left or right foot. If this walking pattern is natural,
track the belt slightly off-center to the side opposite from the belt
movement.
Treadmill belt hesitates when walked/run on See General Maintenance section on Tread-belt Adjustment.
Motor drive belt may be loose.
Motor is not responsive after pressing start 1) If the belt moves, but stops after a short time and the
display shows “LS/LOW SPEED”, run calibration (See section 8.1 on Error Message: LS/LOW SPEED).
2) If you press start and the belt never moves, then the
display shows LS/LOW SPEED, contact service.