19
Dyaco
Canada
Inc
2017
GENERAL MAINTENANCE
1. Do not service internal parts of pedals. If they are found to be worn internally, we recommend
replacing the pedal.
2. Use of lubricants or cleaning solutions other than those specified will result in diminished
performance and a shorter life span for that part.
3. Wipe down all areas in the sweat path with a damp cloth after each workout.
4. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of
three reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten
the bolts sufficiently. We cannot stress this point enough; 90% of calls to the
service department for noise issues can be traced to loose hardware.
II. The crank arm nut needs to be retightened.
III. If squeaks or other noises persist, check that the unit is properly leveled. There
is a total of 4 leveling pads; 2 at the bottom of the rear stabilizer and 2 at the
bottom of the front stabilizer. Use a 14mm wrench (or adjustable wrench) to
adjust the levelers.
MAINTENANCE SCHEDULE
Part Recommended
Action
Frequency
Cleaner Lubricant
Pedals
Ensure that pedals are tight in crank
arms; that all screws on pedals are
tight; and that the pedal straps are not
frayed
Before each
Use
N/A
N/A
Frame
Wipe down by using a soft damp clean
Daily
Water
N/A
Flywheel
Wipe down by spraying on a rag and
applying a light coat to sides of the
flywheel
Weekly
WD-40
Spray
N/A
Brake Pad
Inspect for excessive wear or a dry
leather brake pad
Weekly
N/A
3-IN-ONE Oil or
10W Oil. Do not
use Silicone-
based Lubricants
