- 2 -
M965563 Rev. 1.3
1
IMPORTANT NOTICE TO THE INSTALLER!
Please check with your local Code Authority for acceptable installation
requirements for this Roman Tub set with hand shower. Some local codes
may require a vacuum breaker and/or a pressure balanced mixing valve to
be installed in conjunction with this product.
SPOUT AND T-PIECE ASSEMBLY
Turn off hot and cold water
supplies before beginning.
CAUTION
• Grease O-RING
(3&11)
, Assemble T-PIECE
(9)
onto the SPOUT SHANK
and tighten with COUPLING NUT
(10)
.
• Slide the T-PIECE
(9)
onto SPOUT SHANK
(1)
until it makes contact with
the O-RING
(3)
. Thread COUPLING NUT
(10)
onto SPOUT SHANK
(1)
.
Rotate T-PIECE
(9)
about 10 degrees from center and tighten securely.
Make sure both O-Rings
(3 & 11)
are seated into grooves of T-PIECE
(9)
.
• Assemble RUBBER WASHER
(6)
, FIBER WASHER
(7)
and LOCKNUT
(8)
onto threads of SPOUT SHANK
(1)
. Tighten firmly.
• Insert SPOUT SHANK
(1)
through center hole of sink or mounting surface.
Install ESCUTCHEON
(4)
and WASHER
(5)
. Make sure ESCUTCHEON
snaps into PINS
(2)
and CUTOUT
(X)
shows to the back.
• T-PIECE
(9)
and COUPLING NUT
(10)
are factory pre-installed on
SPOUT SHANK
(1)
and must be removed to install SPOUT SHANK
(1)
.
GROOVE
IN TEE
GROOVE IN TEE
10°
1
2
X
4
5
6
7
8
9
3
10
11
FRONT
Pins are
pre-installed in spout
HOSE ASSEMBLY
HAND SHOWER ASSEMBLY
Note: Back flow prevention and 2.5 GPM flow restrictions are
included with all Roman tub sets with hand shower
• Insert FIBER WASHERS
(1)
into COUPLING NUTS
(2)
of SUPPLY HOSES
(3)
and tighten.
• Drop SPRAY HOLDER
(12)
through ESCUTCHEON
(13)
and WASHER
(14)
and into the fourth hole of the tub ledge (12" 305mm max from SPOUT center)
directed towards tub center. Install RUBBER WASHER
(15)
and
LOCKNUT
(16)
from underside of mounting ledge. Secure
SPRAY HOLDER
(12)
by tightening LOCKNUT
(16)
.
• Install SEAL WASHER
(4)
and connect COUPLING NUT
(5)
of BRAIDED HOSE
(6)
to outlet nipple. Tighten firmly.
• Slip SHOWER HOSE
(10)
with COUPLING NUT
(9)
through SPRAY HOLDER
(12)
and ESCUTCHEON
(14)
.
• Install SEAL
(8)
into COUPLING NUT
(9)
. Connect
COUPLING NUT
(9)
to HOSE NIPPLE
(7)
and tighten.
• INSTALL second SEAL
(4)
and connect HAND
SHOWER
(18)
to SPRAY HOSE END
(17)
. Hand tighten.
9
2
2
1
1
5
6
10
3
3
4
4
BRAIDED
HOSE
7
8
FRONT
13
14
11
12
18
16
17
15
3
8
2
2a
