background image

- 3 -

 

When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear water and dry with a soft cloth. Avoid 
detergents, disinfectants, or cleaning products in aerosol cans. NEVER use abrasive scouring powders or abrasive pads on 
your toilet seat.  Some bathroom chemicals and cosmetics may damage the seat's finish.

WARNING:

 Do not use in-tank cleaners. Products containing chlorine (calcium hypochlorite) can seriously damage fittings in 

the tank. This damage can cause leakage and property damage.
DXV shall not be responsible or liable for any tank fitting damage caused by the use of cleaners containing chlorine (calcium 
hypochlorite). 

7302408-100 (2/2020)

8

CARE AND CLEANING

!

TROUBLESHOOTING

IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY

, repeat Step 9.

IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE

, it is a signal you are wasting water because:

•  The end of the refill tube is inserted into overflow pipe, below water level in tank.  Attach refill tube to overflow pipe  

using "S" clip provided.

•  The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper).  

IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL OF TANK WATER IS SLOW  after valve has been in  
use for some time

, Fluidmaster Model 242 Replacement Seal  may be needed.

Go to our website at www.fluidmaster.com for more solutions to toilet problems.

9

LIFT ARM

FIRST

LIFT ARM

FIRST

LIFT ARM

FIRST

IMPORTANT: Always clear sand  

and rust from system.

•  Make sure water supply is off. 

 Remove valve TOP by lifting arm  

and rotating top and arm 1/8 turn  

counterclockwise,  pressing down  

slightly on cap.

•  While holding a container over  

the uncapped VALVE to prevent  

splashing, turn water supply on  

and off a few times. Leave water  

supply off.

•  Replace TOP by engaging lugs and 

rotating 1/8 turn clockwise. MAKE  

CERTAIN TIP IS TURNED TO THE 

LOCKED POSITION. VALVE MAY  

NOT TURN ON IF TOP IS NOT FULLY 

TURNED TO THE LOCKED POS

For troubleshooting information please contact:

© 2001 Fluidmaster, Inc.

® Registered trademark of Fluidmaster, Inc.

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675

(949) 728-2000 (800) 631-2011

www.fluidmaster.com

NOTE: 

Pictures are representative and may not exactly depict the flush valve.

Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster shall not be responsible or liable for any damages  

caused by products used with Fluidmaster valves that were not manufactured by Fluidmaster, Inc.

Содержание Belshire D22025A101

Страница 1: ... off main water supply c Remove old mounting hardware remove toilet and plug floor waste opening to prevent escaping sewer gases d Remove closet bolts from flange and clean away old wax putty etc from base area NOTE Mounting surface must be clean and level before new toilet is installed IMPORTANT Water supply on the wall is required at 2 1 4 or 8 from centerline of the toilet First suggested posit...

Страница 2: ...E BODY ADJUSTABLE HEIGHT WATER LEVEL ADJUSTMENT ROD TANK LEVER FLUSH VALVE TOP ARM NIPPLE Diagram 1 PARTS FOR WATER CONNECTION SEE STEP 9 CONE WASHER FLAPPER THREADED SHANK SHANK WASHER COUPLING NUT HAND TIGHT ONLY FILL VALVE FLOAT CUP CRITICAL LEVEL MARK C L MUST BE 1 ABOVE OVERFLOW PIPE REFILL TUBE LOCK NUT CLOSET BOLT WASHER NUT Press firmly WAX RING 7 ADJUSTMENTS Adjust water level Water level...

Страница 3: ...r IF FILL VALVE WON T TURN ON OR SHUT OFF or REFILL OF TANK WATER IS SLOW after valve has been in use for some time Fluidmaster Model 242 Replacement Seal may be needed Go to our website at www fluidmaster com for more solutions to toilet problems 9 LIFT ARM FIRST LIFT ARM FIRST LIFT ARM FIRST IMPORTANT Always clear sand and rust from system Make sure water supply is off Remove valve TOP by liftin...

Страница 4: ...Be sure that proper supply tube size is used c Remove obstruction Consult a plumber if necessary d Normal supply pressure must be at least 20 psi Toilet leaks a Poor supply line connection b Poor bowl to tank floor connection a Review Step 6 b Review Step 1 5 Toilet does not shut off a Flush valve chain too tight holding flush valve open b Flush valve seat and or flapper worn or deformed c Sand or...

Отзывы: