- 13 -
13. Loosen the U-Bolts enough to slide the Antenna Hook Mount assembly over your 3" OD
antenna lower element on the base assembly. Position the antenna hook mount approximately
1/2" above the insulated channel as shown below.
14. Tighten the two U-Bolt clamps hardware evenly so the length of the exposed threads is
approximately equal. Any clamp should be tightened evenly from side-to-side with an equal
amount of thread above each nut.
Mounting and using the Optional DXE-VRW-1 Manual Winch
1. Follow the instructions included with the optional
DXE-VRW-1 -
Manual Winch Add-On Kit
to prepare the Manual Winch for installation on the antenna base assembly.
2. Included with optional
DXE-VRW-1 -
Manual Winch Add-On Kit is the stainless steel
hardware for mounting the winch on the pivot base assembly. The hardware includes three 3/8-
16 x 1" long stainless steel hex bolts, six stainless steel 3/8-16 flat washers and three 3/8-16
Stainless Steel Nyloc Nuts.
Loosely install the three sets of stainless steel hardware on the manual winch as shown below.
